- 您现在的位置：买卖IC网 > Sheet目录537 > ZICM0900P2-1C (CEL)MESHCONNECT MODULE 1/4 WAVE WIRE
MeshConnect? Sub-G Module Series
AGENCYCERTIFICATIONS (Continued)
IC Certification — Industry Canada Statement
The term "IC" before the certification / registration number only signifies that the Industry Canada technical specifications
were met.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two con -
ditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement
Section 14 of RSS-210
The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in
excess of Health Canada limits for the general population. Consult Safety Code 6, obtainable from Health Canada's
website: http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/99ehd-dhm237/index-eng.php
CE Certification — Europe ZICM0868P0 (PENDING)
The MeshConnect 868MHz RF modules will be tested and certified for the European Union.
OEM Responsibility to the European Union Compliance Rules
If the MeshConnect module is to be incorporated into a product, the OEM must verify compliance of the final product to the
European Harmonized EMC and Low-Voltage / Safety Standards. A Declaration of Conformity must be issued for each of
these standards and kept on file as described in Annex II of the R&TTE Directive.
The manufacturer must maintain the user's guide and adhere to the settings described in the manual for maintaining
European Union Compliance. If any of the specifications are exceeded in the final product, the OEM is required to
make a submission to the notified body for compliance testing.
OEM Labeling Requirements
The `CE' mark must be placed on the OEM product in a visible location.
The CE mark shall consist of the initials “CE” with the following form:
· If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be adhered to.
· The CE mark must be a minimum of 5mm in height
· The CE marking must be affixed visibly, legibly, and indelibly. Since the 868 MHz
band is not harmonized by a few countries throughout Europe, the Restriction sign must be
placed to the right of the “CE” marking as shown in the picture
Page 14
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
ZICM2410-LED-BRD-1
DAUGHTER CARD MESHCONNECT LED
ZICM2410P0-1C-SN
MODULE 802.15.4 U.FL CONN
ZICM2410P0-KIT2-1
EVALUATION KIT FOR ZIC2410
ZICM357P2-KIT1-1
KIT DEVELOPMENT ENGINEER EM357
ZLNB1001N8TC
IC MUX CTLR TONE/POLARITY 8SOIC
ZLNB100X8TC
IC CTRLR DUAL POLAR SWITCH 8MSOP
ZLNB101X8TC
IC CTRLR DUAL POLAR SWITCH 8MSOP
ZLNB2006Q20TC
MUX DUAL DUAL H/V TONE SW 20QSOP
相关代理商/技术参数
ZICM0900P2-1C-B
功能描述:射频模块 900MHZ W/WIRE ANT. -40C +85C 3.3VOLT
RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
ZICM0900P2-1C-SN
功能描述:射频模块 900MHZ W/WIRE ANT. -40C +85C 3.3VOLT
RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
ZICM0900P2-1C-SN-B
功能描述:射频模块 900MHZ W/WIRE ANT. -40C +85C 3.3VOLT
RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
ZICM0900P2-1CU
功能描述:射频模块 900MHZ U.FL CONN. -40C +85C 3.3VOLT
RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
ZICM0900P2-1CU-B
功能描述:射频模块 900MHZ U.FL CONN. -40C +85C 3.3VOLT
RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
ZICM0900P2-1CU-SN
功能描述:射频模块 900MHZ U.FL CONN. -40C +85C 3.3VOLT
RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
ZICM0900P2-1CU-SN-B
功能描述:射频模块 900MHZ U.FL CONN. -40C +85C 3.3VOLT
RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
ZICM0900P2-KIT1-1
功能描述:射频开发工具 900MHZ EVAL BOARD -40C +85C 3.3VOLT
RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V